Differences

This shows you the differences between two versions of the page.

--- ment [2023/12/27 20:29] – freth
+++ ment [2024/04/10 10:36] (current) – [Notes] freth
@@ Line 3: / Line 3: @@
 ===== Notes =====
+* This tutorial assumes that you already have your entrance tiles prepped; all of the tiles surrounding and including the entrance tile have been dug down to rock.
 * Tunneling in creates a new entrance with a 20 ramp slope down.
 * Improved compass and tool tip mods will help you with corner height.
 * For the best results, I use 30 or 33 slope between top and bottom corners of the entrance tile (outside) depending.
   * 30 is the default height (slope) from floor to ceiling if mining forward.
-  * 33 is the default height height (slope) of a first floor of a building from bottom to top.  Subsequently it is 30 for floors 2 and up.  This is wall height and doesn't take into account the height of a roof.
+  * If you're considering having buildings in your mine, 33 is the default height height (slope) of a first floor of a building from bottom to top.  Subsequently it is 30 for floors 2 and up.  This is wall height and doesn't take into account the height of a roof.  Roof height if the width of the roof is 1 tile is 20 slope high. Roof height if the width of the roof is more than 1 tile (vaulted ceiling) is 38 slope high.
-  * Roof height if the width of the roof is 1 tile is approximately 23-25 slope high.
-  * Roof height if the width of the roof is more than 1 tile is 35 slope high.